Connecting to an Agent Machine

The Software Client for Linux can connect to any remote host with a Anyware agent installed and configured, or a Remote Workstation Card. Remote hosts can be Windows, macOS, or Linux, and connections can be made directly (client direct to host) or brokered through Anyware Manager or a Connection Manager.

Creating Your First Connection

The first step is to create a connection to either your agent (for direct connections) or to your connection manager (for managed deployments).

1. Launch the Software Client for Linux.

2. If this is your first connection, the Software Client for Linux will prompt you to create one:

   

   Click Add a new connection to proceed.

3. In the Add New Connection pane, there are two fields to provide:

   

   • Host Address or Registration Code: Enter the address of the remote system you want to reach (you should have this information from your system administrator). This field accepts IP addresses, domain names, and registration codes, as in these examples:

     • An IP address: 123.456.789.012
     • A domain name: remote-desktops.example.com
     • A registration code: a1b2c3!@#

     Note: Amazon WorkSpaces registration codes

     If you are connecting to an Amazon WorkSpaces desktop, provide your WorkSpaces registration code in this field.

   • Connection Name: Provide a name for this connection. This can be anything; you will use this name to select this connection in future sessions. You can always change it later.

4. Click Add connection.

Once this is done, you'll see the connection you created shown as a clickable button. You can add as many connections as you like, by clicking + Add a new connection at the bottom of the Connect pane.

Connecting to a Session

1. After you have set up at least one connection, the Software Client for Linux will show the available connection options. Click the connection that you want to access.

   

2. Next, provide your username and password:

   

   Note: About authentication credentials

   For managed connections, the authentication screen and validation that happens here is managed by HP Anyware or by your connection broker. The credentials are supplied to you by your system administrators, and are usually your corporate credentials.

   For direct connections where no broker is present, use the credentials for your user account on the remote machine.

3. If your account requires a password change, provide a new password on the Update connection password screen.

   

4. If your system is configured for multi-factor authentication, you will see a Multi-Factor Authentication screen next. The actual view shown here depends on your MFA implementation; in this example, the MFA screen accepts a passcode or sends a push:

   

5. Once your credentials are accepted:

   • If you have a single desktop available, your connection credentials will be used to automatically log into it and your session starts immediately.

   • If you have multiple desktops available, the Software Client for Linux shows you a list of desktops. Click the desktop you want to connect to.

     

Once you are connected, your PCoIP session will begin. The connection will use the display mode you last used (windowed, fullscreen one monitor, or fullscreen all monitors), unless altered by a launch-time configuration.

There may be a delay of a few seconds before you have control of your mouse and keyboard; this is normal.