Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
266
Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card
Last modified: November 8, 2020
269
What are the priorities for video, audio, and USB PCoIP traffic?
PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …
Knowledge Base Article Advisory Performance Peripheral Devices HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
257
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
257
Can I share the network connection of the PCoIP Remote Workstation Card with that of the host PC/workstation?
No, the network interface on the PCoIP Remote Workstation Card is independent to that of the host. It is not possible to communicate to the host operating system via the PCoIP Remote Workstation Card network interface. Therefore, you must connect both the …
Knowledge Base Article Advisory Setup Remote Workstation Card
Last modified: July 3, 2020
252
What do the 4 different types of flash descriptions found in the PCoIP Zero Client logs mean?
These descriptors are found at the start of the event logs on the left hand side of the logs. NOT FOUND : There is no value set in flash for the parameter in question.  As a result, firmware reverts to the default value stored in the firmware image …
Knowledge Base Article Advisory Zero Clients
Last modified: September 12, 2023
250