How do I fix the unsecure browser warning when accessing the PCoIP Management Console web interface?
Problem When accessing the Management Console web interface the web browser displays a message such as "This site is not secure", "Your connection is not secure" or "Your connection is not private"   Cause The web browser cannot validate the security …
How to configure an Amazon Network Load Balancer (NLB) with the PCoIP Connection Manager and Security Gateway or HP Anyware Connector
The following article provides an example on how to  setup an Amazon Network Load Balancer with the PCoIP Connection Manager and Security Gateway (CM/SG) or HP Anyware Connector (CAC). Prerequisites:   Connection Manager & Security Gateway: 1. Deploy the …
What does "No Available Hosts for Connection" mean?
The message "No Available Hosts for Connection" appears if the PCoIP Zero Client has enabled the Host Discovery feature and tries to establish a session but cannot find a PCoIP Remote Workstation Card that is not currently in a session on the network. If …
How can I determine the frame rate at a PCoIP protocol client?
Answer: There are a multiple ways to determine the frame update rate displayed at the PCoIP Zero Client.    Note: the frame rate displayed at the client this may be different than the source display frame rate when in a congested network environment.  Log …
Display resolution, topology, image artifacts or rendering-performance issues in HP Anyware with a GPU
Symptoms If you are using HP Anyware's Graphics agents with a GPU, either Nvidia GRID or AMD FirePro, the following issues may be caused by incorrect GPU driver: Image tearing Image artifacts Slow connection times Display topology issues Low frame rates …
Why is the BIOS not visible when my Dell workstation boots with a PCoIP Remote Workstation Card?
Scenario The BIOS on a Dell R5500/R5400 is not visible on boot up. After the OS loads, the monitor then displays the desktop. On some graphic cards, only the primary port is active during the POST phase of the host PC boot process. For example, when using …
FAQ's Peripheral Devices
FAQ's - Webcam   General  Health Checks Troubleshooting How to troubleshoot Webcams Webcam will not show under attached devices in Zero Client. Webcam shows status as "Not Supported" in attached device. Webcam shows status as "USB device not supported …
Why does my PCoIP Zero Client indicate that it is unable to verify the View Connection Server's identity after the CA's root certificate has been uploaded via AWI and/or the PCoIP Management Console?
Problem The PCoIP Zero Client is presenting a certificate error when the server's corresponding Root CA or Intermediate Certificate has been loaded into the PCoIP Zero Client certificate store. The PCoIP Zero Client has a certificate check mode configured …
Troubleshooting artifacts in a PCoIP Session
Problem During a PCoIP Session artifacts are appearing on the screen. The artifacts may stay or slowly disappear.   Cause and Resolution There are may reasons artifacts may appear on the screen. Some may be source issues such as the application or …