How does device discovery work with the PCoIP Management Console 2.x and 3.x?
The PCoIP Management Console must discover all of the PCoIP devices that it manages and therefore supports the discovery of devices using three mechanisms: DHCP Option discovery DNS DNS Service Record Discovery DNS-Based Discovery Prefix Manual Discovery …
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
The PCoIP session ended abruptly and the PCoIP Zero Client PCoIP Splash screen appears
Problem Occasionally issues can cause the PCoIP Zero Client to reboot. Issues such as the ones listed below are good signs that the PCoIP Zero Client has rebooted even though at first it may not be certain the PCoIP Zero Client rebooted. Unexpectedly the …
Can I use an Ethernet hub or half-duplex network connection with a PCoIP Zero Client or PCoIP Remote Workstation Card?
No. PCoIP technology requires a full-duplex Ethernet connection from end to end. In modern networks, half-duplex links can still exist when using technologies such as Wi-Fi or point to point Wi-Fi or Microwave links. Older communication equipment in wired …
No audio when using Unified Communications with a USB headset
Problem Some users have reported no audio when using Unified Communications solution in firmware 4.7.0, they can only hear the ring of the incoming call and when the call is answered there is no Rx/Tx audio.   Cause This issue has been tracked down to the …
What does "IPC: Frame encode took xxx ms so far. Dropping down the quality to index x." in the log files indicate?
Answer: In this case, the imaging encoder has determined that too many bits were being sent in the upper portion of the frame (i.e. flooding) which causes the frame to take longer to encode, and therefore appears unresponsive to the user (> 750 ms to …
Why does my Tera2 PCoIP Zero Client perform poorly on a WAN, compared to a software client on the same network?
If you are experiencing refresh issues of image data when scrolling through text and/or images using a PCoIP Zero Client on a WAN network, ensure that you enable the Low Bandwidth Text Codec (LBTC) setting. Note: The LBTC setting is available on TERA2321 …
Can a WAN accelerator be used to improve the performance of PCoIP sessions?
PCoIP does not benefit from a WAN accelerator, legacy WAN accelerator solutions use different methods to improve the performance of applications operating over congested networks. These methods include compressing packets, implementing proxy servers that …