How do I get a PEM certificate from Windows for IEEE 802.1x Network Authentication?
The following is an example of how to convert a DER encoded certificate to .pfx and finally to pem format required for import. If the certificate generated is in .DER format, you will need to convert it to .pfx before you can convert it to .PEM format for …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4150
How can I change USB authorizations for PCoIP Zero Client?
USB devices can be enabled or disabled which allows IT control of the use of peripherals with HP Anyware PCoIP Agent, VMware Horizon View using PCoIP protocol, or PCoIP Remote Workstation Cards. PCoIP Zero Clients provide unique USB security features that …
Knowledge Base Article Tutorial Management Peripheral Devices Security Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4118
PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
Knowledge Base Article Troubleshooting Performance Display Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
4054
What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
Knowledge Base Article Troubleshooting Display HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3892
What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3873
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3788
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3534
Is Network Quality of Service - QoS Required for PCoIP protocol deployments?
Since PCoIP is a real-time protocol, quality of service (QoS) must be implemented for virtual desktop or remote workstation deployments using the PCoIP protocol in constrained environments. Teradici previously recommended QoS as essential for successful …
Knowledge Base Article Advisory HP Anyware Remote Workstation Card Zero Clients
Last modified: February 6, 2024
3534