How can I tell which monitors are connected and if a USB device is connected locally or bridged on a PCoIP Zero Client?
Answer: From your Web browser, enter the IP address of your PCoIP Zero Client. Log in to the user interface with your user credentials. (Note: Depending on your specific setup, a password may not be required.) From the Info menu, select Attached Devices . …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: October 31, 2022
305
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
298
When the network experiences periods of high congestion what will happen to the users experience?
PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …
Knowledge Base Article Tutorial Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: December 9, 2022
296
Why do PCoIP Zero clients fail to establish Imprivata OneSign sessions when the OneSign Appliance Verification setting equals no verification?
This happens when the PCoIP Zero Client trust store contains a certificate issued by the OneSign server that does not match the certificate used by the OneSign server.   Workaround Ensure the PCoIP Zero Client trust store does not contain …
Knowledge Base Article Troubleshooting Security Zero Clients
Last modified: September 14, 2023
292
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
290
Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
290
How many characters are supported in the PCoIP Zero Client Pool (Desktop) Name to Select field?
Answer: On a PCoIP Zero Client, when selecting any of the View Connection Server options for the Connection Type other than View Connection Server + Kiosk, the advanced button will present an option called Pool Name to Select.  (Note, in older versions of …
Knowledge Base Article Advisory Zero Clients
Last modified: September 25, 2023
289
PCoIP Firmware 4.0.2 Issue Notification
Scenario There is an issue with firmware 4.0.2 where the use of the PCoIP Management Console 1.8.0 could result in rendering the Tera2 zero client non-functional and non-recoverable. This issue may be encountered intermittently when deploying profiles …
Knowledge Base Article Advisory Zero Clients
Last modified: August 7, 2023
281