What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3873
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3788
Is Network Quality of Service - QoS Required for PCoIP protocol deployments?
Since PCoIP is a real-time protocol, quality of service (QoS) must be implemented for virtual desktop or remote workstation deployments using the PCoIP protocol in constrained environments. Teradici previously recommended QoS as essential for successful …
Knowledge Base Article Advisory HP Anyware Remote Workstation Card Zero Clients
Last modified: February 6, 2024
3534
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3254
How do I remotely power on the host PC/workstation through its network interface (PC NIC) from a PCoIP Zero Client?
Answer: Follow the steps below to set up the host PC NIC for Wake-on-LAN (WOL) feature, to allow a workstation with a PCoIP Remote Workstation Card (host card) installed to be woken up by a PCoIP Zero Client. You can also remotely power on your …
Knowledge Base Article Tutorial Remote Workstation Card Zero Clients
Last modified: September 14, 2023
3053
What are the jumpers and LEDs on the Tera2 PCoIP Remote Workstation Card used for?
All external connectors on Tera2 PCoIP host cards are for diagnostic purposes. Jumpers J15 and J25 are configurable and their functions are described below. If you want Tera1 jumper explanations instead, refer to  What are the jumpers on the Tera1 host …
Knowledge Base Article Troubleshooting Setup Remote Workstation Card
Last modified: April 17, 2024
3043
Why do I get a gray screen when connecting from the HP Anyware PCoIP Software Client to a PCoIP Remote Workstation Card?
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …
Knowledge Base Article Troubleshooting Display Remote Workstation Card
Last modified: July 9, 2024
2910