Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
290
Why does the mouse and keyboard to work on my Fujitsu CELSIUS (C620, M730, or M720) when using a PCoIP Remote Workstation Card?
Answer: In some cases, when connected to a PCoIP Remote Workstation Card, users can't use their mouse and keyboard. Fujitsu has resolved the issue via a BIOS update. For more information, or for support related to this issue, please contact Fujitsu or …
Knowledge Base Article Troubleshooting Peripheral Devices Remote Workstation Card
Last modified: November 22, 2022
294
Why Imported Profile(s) from PCoIP Management Console 1.x/2.x to PCoIP Management Console 3.x cannot be applied? Status shows skipped.
Scenario Imported a profile from PCoIP Management Console 1.x /2.x  to PCoIP Management Console 3.x where firmware 6.0.0 is the only uploaded version in Settings -> Software. Pushing the profile to PCoIP Zero Clients results in a 'skipped' status.   Cause …
Knowledge Base Article Troubleshooting Management Management Console
Last modified: September 19, 2023
292
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 18, 2022
272
Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card
Last modified: November 8, 2020
269
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
257
Wacom Cursor Offset with Autodesk Flame
Description : The Autodesk Flame by design introduces mouse offset when it is loaded. HP Anyware does not has an option to compensate for this offset in the Flame. As a result, users will see mouse offset in the Flame application.   Workaround : Since …
Knowledge Base Article Troubleshooting
Last modified: September 3, 2023
246
Why does traffic to my PCoIP Remote Workstation Card exceed the configured bandwidth settings?
Problem After setting the bandwidth limits on the PCoIP Remote Workstation Card in the PCoIP Remote Workstation Card AWI, excessive traffic is seen going to the PCoIP Remote Workstation Card from the PCoIP Zero Client. Cause PCoIP Remote Workstation …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: September 3, 2023
243